The Norland Opticure 4 Light Gun (P/N 5082 or P/N 5082T) is a small handheld light source which provides a high intensity beam of long wave ultraviolet light in an easy to control form. This light source is designed for continuous use on production lines where small areas of UV adhesive need to be cured quickly and precisely.

Recommended for; bonding fibre optic splices, terminating connectors, lens bonding, printed circuit board repairs, wire tacking and mounting precision components in optics and electronics.

The Opticure 4 has a high intensity, quartz halogen lamp (P/N 5011) that gives a minimum output of 50mW/sq.cm in the 340-400 nm range. The unit may also be equipped with a bulb to cure visible material (P/N 5010) in the 420-470 nm range. When the light source trigger is activated an audible tone sounds every ten seconds. At any time the curing cycle can be discontinued by pressing the trigger switch. The light is focused into a 84mm long, swivel mounted, curved fiber optic light guide, which gives the operator great versatility in directing the light. The fibre optic tip should be held within approximately 12mm of the surface being cured to provide full intensity.

The Opticure 4 saves time because it concentrates the light exactly where it is needed to speed the cure. The light gun can be made more versatile with accessory light guides available in larger and smaller diameters and lengths. Because of the high intensity UV and visible light emitted by the unit, protective glasses are recommended for the user. A pair of protective glasses are included when you purchase any Opticure 4.

The Opticure 4 can also be purchased with a timer that has settings of 10, 20, 30 ,40 or 50 seconds and continuous. The Opticure 4 T (P/N 5082T) is recommended for use on production lines that have a procedure requiring specific time requirements for curing. The timer makes it easier for the operator to follow the curing procedure.

Additional products: